Using a sponge mop will allow you to clean your floors without the dreaded idea of touching the dirty mop head. Moreover, with a sponge mop, you don’t have to use a bucket to get rid of the excess water in your mop. Even though sponge mops have their style, they all have the same feature or mechanism that removes excess water. Smaller sponge mops use cellulose sponge, and this is the type that wears off fast. Although the bigger ones are more durable, they are more cumbersome to use and store. Thus, this article will guide you on how to remove sponge from mop and replace it with a more durable type.
Quick Tips on How to Remove Sponge from the Mop
- Before we begin the steps on how to remove sponge from mop, assemble the following materials:
- A measuring tape
- A cellulose sponge refill
- A sharp knife
- Polyester sponge (you can buy from any home improvement store)
- Rubber cement
- The next step on how to remove sponge from mop is to measure your sponge refill and take note of its dimensions. There’s a taper to the shape, and the height difference reflects that. You can also make the sponge a bit thicker for more strength.
- Get a big polyester sponge split it into half. Choose a durable sponge that is usually used for heavy cleaning. But, most of them are not found in grocery or drug stores. Make sure that the sponge’s size is correct.
- Test if the sponge can endure the rubber cement. Check if your sponge will melt. If it does, then try using milder rubber cement. These sponges are heavy-duty enough to resist the melting from the rubber cement. Free-running cement can melt the sponges more than the thicker ones.
- Discard the sponge from the used mop head.
- Shape and form the polyester sponge base from the shape of the sponge refill. Use a thin-bladed knife and a good pair of scissors for some snipping. Flatten one side of the sponge (the one where the rubber cement is). Small sponges contract when dry, so the plastic plate may warp. If this happens, you can shape the sponge to make it fit in the plate.
- Apply rubber cement liberally, especially at the edges, and install your sponge.
- Secure the sponge to the mop base by sealing the hinged squeezer and tying it to the mop hand in a clamped position with some cordage.
- Lastly, let the glue dry for over a day and remove the cordage holding the water squeezer down.
Seat cushions and pillow may also be used. They are more durable than those cellulose sponges but not as sturdy as polyester. Apply just a small amount of rubber cement as this might melt the foam. Let it dry a little, and then gently clamp the foam. Find out more about sponge mop heads here!
Sponge mops are practical house cleaning tools that will help keep your house floors clean. Most of the time, you use them on dirty floors, and they easily absorb dirt and grime, especially when your floor is filthy. Fortunately, a sponge mop has a mechanism that can squeeze out extra water and moisture without you touching the dirty mop head. Plus, you can easily change the mop head if it gets too filthy, so remember these easy steps on how to remove sponge from mop.